Mylee Soft Wax - Honey

Product Code: MYLW01

Step 1: Place the Wax in the heater (remove bucket from heater for this step) and let heat up, always test the temperature on the inside of your wrist the wax should be warm and should
not burn the skin.

Step 2: Next you'll want to prepare the skin, massage the pre-wax care gel over the area you’d like to wax, this cleanses the skin and ensures there is no oil or residue left on the skin that could interfere with the end result. Wait for this to dry before applying any wax

Step 3: Using a spatula spread a layer of wax onto the area to be treated in the direction of hair growth.

Step 4: Add a wax strip over the Wax, and then pull off wax with a firm action against the direction of hair growth.

Step 5: Repeat until all hair is removed in the area.

Step 6: Gently massage a small amount of aftercare lotion over the waxed area to cool, soothe and hydrate the skin.

Mastering the Mylee Advanced Stripless Wax is all about that "cool and pull" technique.

• Getting the temp right is everything. You want your wax to look like thick, gooey honey - not runny water!
  Melt your wax using a high heat for about 15-20 minutes, then turn the dial down to medium. Our Digital wax Heater does this for you automatically! If the wax runs off your spatula instantly, it’s too hot. Let it sit for a minute until it stays on the stick for a few seconds when you twirl it.

• When you apply your wax in a strip, make sure the very end (where there is no hair) is a little bit thicker than the rest. This creates a "pull tab" or lip. It means you can get a firm grip and flick it back without having to pick at the edge.
  
• Don't be shy with that spatula! If you apply the wax too lightly, it won't "shrink-wrap" the hair.
  
• Use firm, even pressure when spreading the wax in the direction of hair growth. You want to really push the wax into the hair follicles so it grabs every single strand from the root.
  
• Hold the skin as taut as possible. When you pull the wax off, keep your hand parallel and close to the skin, pulling back in the opposite direction of growth. Think of it as a "flick" rather than a "lift" - it’s faster, smoother, and way less "ouchy."
  
• As soon as you’ve pulled the wax strip off, immediately press your palm firmly onto the skin for a few seconds. The pressure confuses your nerves and stops the "sting" before it even starts. Total game-changer!
  
• Use the Mylee Silicone Bucket for your beads. Once you’re finished and the wax has cooled completely, just "pop" the hardened wax disc out. You can save it for your next session or wipe the bucket clean in seconds. No mess, no stress.

Glyceryl Rosinate, Paraffinum Liquidum (Mineral Oil), Mel (Honey).